Rotimatic

All your roti's are belong to teh hackz0R!

Profile / Other Projects

ThanX Vinita for dropping a rabbit hole in the lab  ;+)

Original Teardown

https://wiki.recessim.com/view/Roti_making_robot_rotimatic

SPI dump

Initial attempt with chip in circuit, 3v3 power from Tigard, WP & HOLD tied together with 10k resistor and HOLD 10k to ground.

PIC32 held in reset by connecting MCLR to ground via pins 1 & 3 on P8 (presumably populated factory programming header)

~/tigard/roti$ sudo flashrom -p ft2232_spi:type=2232H,port=B,divisor=4 --flash-name
flashrom is free software, get the source code at https://flashrom.org

Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
Found Eon flash chip "EN25QH64" (8192 kB, SPI) on ft2232_spi.
vendor="Eon" name="EN25QH64"

~/tigard/roti$ sudo flashrom -p ft2232_spi:type=2232H,port=B,divisor=4 --flash-size
Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
Found Generic flash chip "unknown SPI chip (RDID)" (0 kB, SPI) on ft2232_spi.
===
This flash part has status NOT WORKING for operations: PROBE READ ERASE WRITE
This flash part has status UNTESTED for operations: WP
0

Same setup as above, no device detected initially. Pulled Chip Select high then low thru 10k resistor and then...

~/tigard/roti$ sudo flashrom -p ft2232_spi:type=2232H,port=B,divisor=4 -r roti-b
Found Eon flash chip "EN25QH64" (8192 kB, SPI) on ft2232_spi.
Block protection could not be disabled!
Reading flash... done.
Error: WIP bit after WRSR never cleared

Generated 8MB file, saved to disk.

Revised process, leave Chip Select floating, works first time on power cycle. Momentarily ground thru 10k resistor to reset for additional commands/queries.

~/tigard/roti$ sudo flashrom -p ft2232_spi:type=2232H,port=B,divisor=4 --flash-size
Found Eon flash chip "EN25QH64" (8192 kB, SPI) on ft2232_spi.
8388608

Repair Budgeting

...and now for Round II

• $60 busted up broken up rotimatic
• $62 Kneading/Stirrer Cup†
• $60 Flour Container†
• $39 Water Container†
• $35 Oil Container†
• $45 Front Door†
• $37 Dough Tray†
• $52 Kicker Pad†
  • $390 Sub Total Machine & Parts
• $7.99 Disinfecting Wipes
• $3.49 Isopropyl Alcohol
• $3.99 Pack of Sharpies
• $13.99 Lube
• $20 gas to here and there
  • $439.46 Estimated Total ($1,599/$1,399 new/re-manufactured)†

† Parts priced from rotimatic.com